Ariat Men´s Western Riding Boot 23151 CATALYST PLUS Bar Top Bison Bunkhouse Beige - Brown
Ariat brand classic men's riding boots with foot stabilizing ATS technology!
The shaft is made of soft pigskin.
The foot area is sewn with a textile fabric. The heel area was equipped with a cow split leather to optimize the hold.
ATS technology is a foot stabilizing and cushioning footbed. Instead of the classic metal spring, a lighter fork joint support is used. The special fork support maintains balance, reduces muscle fatigue (thanks to torsional stability) and injuries.
In addition, the support allows natural compliance in the forefoot area. The special footbed has a moisture-repellent coating that keeps the feet dry and also has an antibacterial effect.
The low friction surface reduces the formation of heat and bubbles. The gel spring system in the forefoot area serves as a shock absorber and relieves the important pressure points. The pressure on knees, hips and back is reduced and in addition, the roll-off comfort is increased. The heel cup stabilizes and supports the foot.
The upper material for the Ariat 23151 Western riding boot is a very robust, waxed and oiled full grain cowhide leather (PREMIUM FULL GRAIN).
The oiling of the leather gives each boot a very striking look.
To facilitate entry and exit, the 13-inch high shaft has a deep V-cut and four entry aids each.
The boot has an approx. 0.8 cm deep spore edge of plastic.
The abrasion-resistant Durtread Outsole outsole from Ariat is sewn to the outer frame and additionally increases wearing comfort due to its special design.
The boots have a square WIDE SQUARE TOE bar.
The boot has a very good fit and a comfortable instep height.
The Ariat CATALYST PLUS 23151 Western riding boot has a shaft height of 13 inches (approx. 33 cm).
The Durtread sole is approx. 1 cm thick.
The HORSEMAN heel is 1.5 inch approx. 3.8 cm high.
The bootleg has a circumference of approx. 40 cm. Depending on the shoe size, this can increase or decrease by 1-2 cm.
The plastic spore edge is approx. 0.8 cm deep.
The boots have a D width (medium width for men)
Important notes and tips:
Due to the handmade production method of the Ariat boots there may be differences in colour or design compared to the pictured examples!
Each pair of ARIAT boots is unique!
Waxed and oiled leathers (PREMIUM FULL GRAIN) also require special care products.
With the welted production method (GOODYEAR WELT) a small running-in phase must always be observed!
The spores and spore straps shown are not included.